Load data for .30 PICRA + .308 | 180gr | Nosler Partition SP

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 180gr \| Nosler Partition SP
Manufacturer SKU:	16331
Bullet Weight:	180gr \| 11.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.260" \| 32.0mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.379" \| 9.6mm
Shank Seated Depth:	0.379" \| 9.6mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B4114_C311
Last updated:	2025-01-01

Load data for 48 loads in caliber .30 PICRA with .308 | 180gr | Nosler Partition SP bullet and 24 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	72%	35317	87%	**09	100%
Accurate 4100	<<locked>>	74%	36332	89%	**14	93%
[Accurate No. 11 FS]*	<<locked>>	82%	34389	85%	**01	85%
Accurate No. 9	<<locked>>	63%	35723	88%	**88	97%
Accurate TCM	<<locked>>	63%	35433	87%	**84	98%
Alliant 2400	<<locked>>	69%	34606	85%	**88	95%
Alliant BLUE DOT	<<locked>>	73%	36361	90%	**88	100%
Hodgdon H110	<<locked>>	78%	34940	86%	**20	90%
Hodgdon LilGun	<<locked>>	80%	36506	90%	**70	96%
Hodgdon TrailBoss	<<locked>>	96%	25106	62%	**0	100%
Maxam CSB 1	<<locked>>	64%	35839	88%	**4	100%
Ramshot Enforcer	<<locked>>	71%	36318	89%	**20	97%
ReloadSwiss RS 14	<<locked>>	94%	23728	58%	**7	100%
ReloadSwiss RS 30	<<locked>>	95%	35114	86%	**53	93%
SNPE Vectan A0	<<locked>>	64%	35882	88%	**20	100%
SNPE Vectan BA6 1/2	<<locked>>	97%	35940	88%	**14	98%
SNPE Vectan BA7 1/2	<<locked>>	67%	35375	87%	**73	100%
[Somchem S265]*	<<locked>>	86%	36100	89%	**94	89%
Vihtavuori 3N38	<<locked>>	68%	34925	86%	**45	100%
Vihtavuori N105	<<locked>>	71%	34621	85%	**48	100%
Vihtavuori N110	<<locked>>	87%	34766	86%	**14	96%
Vihtavuori N32C Tin Star	<<locked>>	77%	34185	84%	**9	100%
Vihtavuori N350	<<locked>>	63%	35549	88%	**76	100%
[Winchester 296]*	<<locked>>	77%	35201	87%	**47	86%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	25875	64%	**1	100%
[Accurate 4100]*	<<locked>>	61%	23221	57%	**17	85%
[Accurate No. 11 FS]*	<<locked>>	74%	27151	67%	**96	81%
Accurate No. 9	<<locked>>	61%	33576	83%	**61	97%
Accurate TCM	<<locked>>	61%	33272	82%	**48	97%
Alliant 2400	<<locked>>	61%	26556	65%	**73	91%
Alliant BLUE DOT	<<locked>>	61%	25831	64%	**37	97%
[Hodgdon H110]*	<<locked>>	63%	21611	53%	**07	80%
[Hodgdon LilGun]*	<<locked>>	61%	18855	46%	**4	85%
Hodgdon TrailBoss	<<locked>>	67%	15200	37%	**6	100%
Maxam CSB 1	<<locked>>	61%	32822	81%	**5	100%
Ramshot Enforcer	<<locked>>	61%	26208	65%	**70	92%
ReloadSwiss RS 14	<<locked>>	66%	14504	36%	**3	100%
[ReloadSwiss RS 30]*	<<locked>>	74%	20450	50%	**1	81%
SNPE Vectan A0	<<locked>>	61%	33011	81%	**1	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	61%	13779	34%	**7	82%
SNPE Vectan BA7 1/2	<<locked>>	61%	30501	75%	**17	100%
[Somchem S265]*	<<locked>>	69%	22539	56%	**4	80%
Vihtavuori 3N38	<<locked>>	61%	28137	69%	**53	100%
Vihtavuori N105	<<locked>>	61%	25135	62%	**30	100%
[Vihtavuori N110]*	<<locked>>	61%	16215	40%	**2	82%
Vihtavuori N32C Tin Star	<<locked>>	61%	24453	60%	**4	100%
Vihtavuori N350	<<locked>>	60%	32706	81%	**47	100%
[Winchester 296]*	<<locked>>	70%	27702	68%	**32	81%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data